LTC4257
9
4257fb
probing exceeds 75ms, the LTC4257 may overheat. In this
situation, the thermal protection circuit will engage and
disable the classification current source in order to protect
the part. The LTC4257 stays in classification mode until
the input voltage rises above the UVLO turn-on voltage.
Undervoltage Lockout
IEEE 802.3af dictates a maximum turn-on voltage of 42V
and a minimum turn-off voltage of 30V for the PD. In
addition, the PD must maintain large on-off hysteresis to
prevent resistive losses in the wiring between the PSE and
the PD from causing start-up oscillation. The LTC4257
incorporates an undervoltage lockout (UVLO) circuit that
monitors line voltage to determine when to apply power
to the PD load (Figure 5). Before power is applied to the
load, the V
OUT
  pin is high impedance and at ground
potential since there is no charge on capacitor C1. When
the input voltage rises above the UVLO turn-on threshold,
the LTC4257 removes the classification load current and
turns on the internal power MOSFET. C1 charges up under
LTC4257 current limit control and the V
OUT
 pin transitions
from 0V to V
IN
. This sequence is shown in Figure 1. The
LTC4257 includes a hysteretic UVLO circuit that keeps
power applied to the load until the input voltage falls
below the UVLO turn-off threshold. Once the input voltage
drops below 30V, the internal power MOSFET is turned
off and the classification load current is re-enabled.
C1 will discharge through the PD circuitry and the V
OUT
pin will go to a high impedance state.
Input Current Limit
IEEE 802.3af specifies a maximum inrush current and also
specifies a minimum load capacitor between the GND and
V
OUT
 pins. To control turn-on surge current in the system,
the LTC4257 integrates a current limit circuit with the
onboard power MOSFET and sense resistor to provide a
complete inrush control circuit without additional external
components. The LTC4257 limits input current to less
than the 400mA maximum specified by 802.3af, allowing
the load capacitor to ramp up to the line voltage in a
controlled manner. During this ramp up, a large amount of
power is dissipated in the power MOSFET. The LTC4257
Figure 5. LTC4257 Undervoltage Lockout
APPLICATIO S I FOR ATIO
U
U
U
GND
C1
5礔
MIN
V
IN
8
4
V
OUT
5
LTC4257
4257 F05
TO
PSE
UNDERVOLTAGE
LOCKOUT
CIRCUIT
PD
LOAD
CURRENT-LIMITED
TURN ON
+
INPUT
LTC4257
VOLTAGE
POWER MOSFET
0V TO UVLO*
OFF
>UVLO*
ON
*UVLO INCLUDES HYSTERESIS
RISING INPUT THRESHOLD E 39.2V
FALLING INPUT THRESHOLD E 30.5V
相关PDF资料
LTC4260IUH#PBF IC HOT SWAP CNTRL I2C 32-QFN
LTC4261IGN-2#PBF IC CTRLR HOTSWAP W/ADC 28-SSOP
LTC4263IS#TRPBF IC IEEE 803.2AF CNTRLR 14-SOIC
LTC4268IDKD-1#PBF IC PD HIGH POWER W/CNTRL 32-DFN
LTC4274CUHF#PBF IC CONTROLLER POE 38-QFN
LTC4280CUFD#PBF IC CONTROLLER HOT SWAP QFN-24
LTC4300-1IMS8#TRPBF IC HOTSWAP 2WIRE BUS BUFFR 8MSOP
LTC4300A-2IMS8#TRPBF IC BUFFER BUS 2WR HOTSWAP 8-MSOP
相关代理商/技术参数
LTC4257CS8-#1TRPBF 制造商:LINEAR_TECH 功能描述:
LTC4257CS8#PBF 功能描述:IC CTRLR INTFACE PWR/ETHER 8SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 热交换 系列:- 标准包装:50 系列:- 类型:热交换控制器 应用:-48V 远程电力系统,AdvancedTCA ? 系统,高可用性 内部开关:无 电流限制:可调 电源电压:11.5 V ~ 14.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:10-TFSOP,10-MSOP(0.118",3.00mm 宽) 供应商设备封装:10-MSOP 包装:管件
LTC4257CS8#TR 功能描述:IC CTRLR INTFACE PWR/ETHER 8SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 热交换 系列:- 标准包装:50 系列:- 类型:热交换控制器 应用:-48V 远程电力系统,AdvancedTCA ? 系统,高可用性 内部开关:无 电流限制:可调 电源电压:11.5 V ~ 14.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:10-TFSOP,10-MSOP(0.118",3.00mm 宽) 供应商设备封装:10-MSOP 包装:管件
LTC4257CS8#TRPBF 功能描述:IC CTRLR INTFACE PWR/ETHER 8SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 热交换 系列:- 标准包装:50 系列:- 类型:热交换控制器 应用:-48V 远程电力系统,AdvancedTCA ? 系统,高可用性 内部开关:无 电流限制:可调 电源电压:11.5 V ~ 14.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:10-TFSOP,10-MSOP(0.118",3.00mm 宽) 供应商设备封装:10-MSOP 包装:管件
LTC4257CS81 制造商:Linear Technology 功能描述:
LTC4257CS8-1 功能描述:IC CTRLR INTFACE PWR/ETHER 8SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 热交换 系列:- 标准包装:50 系列:- 类型:热交换控制器 应用:-48V 远程电力系统,AdvancedTCA ? 系统,高可用性 内部开关:无 电流限制:可调 电源电压:11.5 V ~ 14.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:10-TFSOP,10-MSOP(0.118",3.00mm 宽) 供应商设备封装:10-MSOP 包装:管件
LTC4257CS81#PBF 制造商:Linear Technology 功能描述:
LTC4257CS8-1#PBF 功能描述:IC CTRLR INTFACE PWR/ETHER 8SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 热交换 系列:- 标准包装:50 系列:- 类型:热交换控制器 应用:-48V 远程电力系统,AdvancedTCA ? 系统,高可用性 内部开关:无 电流限制:可调 电源电压:11.5 V ~ 14.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:10-TFSOP,10-MSOP(0.118",3.00mm 宽) 供应商设备封装:10-MSOP 包装:管件